Digital Leveling Systems
Electronic Water Level
Improved design for the new millennium
| |
Now available with mineral oil eliminating evaporation and environmentally friendly. |
Tougher, shock-resistant plastic Improved electronics & power switch All components sold separately & easily replaced if damaged
- Easy, accurate, digital leveling for manufactured homes
- Totally sealed - just check fluid level monthly
- Reads in inches and tenths
- Typically will level to .2" (1/5") over entire radius
- 100' tubing
- Fluid is safe to sub-zero temperatures
- Magnet holds display in place when necessary
- Retractable reel for easy storage and handling
 To level frame of manufactured home:
Unwind the length of tubing needed, (in most cases fully unwind). Place the reel on its side. The reservoir may be removed from the reel if necessary. (see picture to left). Place the display on the bottom lip of the frame where you want to start and level the remainder of the frame to this reading.
Example: In the picture, (lower right), the display reads 5.0. If half way down the frame it reads 4.0, this part of the frame is 1.0" too low, raise the frame to the 5.0 reading you started with.
Blocks or columns may be leveled by placing the display directly on top of the wedges and leveling to the same reading each time.
The level can also be used inside the home from side to side or room-to-room, as well as on an empty lot to tell how high one end of the home will be compared to the other end.
The level also works well on footers, foundations, sub-grades, concrete pads, decks, etc.
Call 1-800-827-3755 for more information
|
